To Next Page

To Previous Page

Commands listed in alphabetical order

POWer:POWer<

x>:RESUlts:CURRentacq:STDDev? (Query Only)

This command queries the standard deviation value of the current acquisition for

the measurement parameter in the spe ciﬁed power measurement badge. The

power measur

ement badge is speciﬁed by x.

Conditions

Requires option 5-PWR, SUP5-PWR, or 5-PS2.

Group

Power

Syntax

POWer:POWer<x>:RESUlts:CUR Rentacq:STDDev?<QString>

Arguments

<QString> = parameters of the mea surements. The details of the parameters for

the Power measurements are listed below:

For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"

"VCFACTOR" | "IRMS" | "VRMS".

For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"

"TTLENRG".

For dV by dt m easurement, the parameter is “DVBYDT”.

FordIbydtmeasurement,theparameteris“DIBYDT”.

For SOA measurement, the p arameter is “SOAHITSCNT”.

For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.

For Switching Ripple measurement, the parameters are “SWRIPRMS” |

“SWRIPPKPK”.

For Cycle Period measurement, the parameters is “PRIOD”.

For Cycle Frequency meas urement, the parameters is “FREQ”.

For Positive Duty Cycle measurement, the parameters is “PDUTY”.

For Negative Duty Cycle measurement, the parameters is “NDUTY”.

For Positive Pulse Width measurement, the parameters is “PPULSE”.

For Negative Pulse Width measurement, the p arameters is “NPULSE”.

For Cycle Amplitude measurement, the parameters is “AMPL”.

For Cycle Peak–Peak measurement, the parameters is “PKPK”.

For Cycle Top measurement, the parameters is “HIGH”.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-579

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58