Commands listed in alphabetical order
Group
Digital
Syntax
REF<x>_DALL:LABel:YPOS <NR3>
Arguments
<NR3> is the y-position, in pixels relative to the baseline of the waveform, of
the group.
Examples
REF1_DALL:LABel:YPOS 50 sets the y position to 50.
REF1_DALL:LABel:YPOS? might return :REF1_DALL:LABEL:YPOS 0.0E+0
indicating the y position of the label is at the baseline of the waveform.
REF<x>_D<x>:LABel:COLor
This command sets or queries the color of the label of the specified digital bit.
The reference is specified by x.
Group
Digital
Syntax
REF<x>_D<x>:LABel:COLor <QString>
Arguments
<QString> is the label color. To return the color to the default color, send an
empty string as in this example:
:REF5_D1:LABEL:COLOR "".
Examples
REF1_D1:LABel:COLor "#FF0000" sets the color to red.
REF1_D1:LABel:COLor? might return :REF1_D1:LAB EL:COLOR "#FFFF00"
indicating the color is yellow.
REF<x>_D<x>:LABel:FONT:BOLD
This command sets or queries the bold state of the label of the specified digital bit.
The reference is specified by x.
Group
Digital
Syntax
REF<x>_D<x>:LABel:FONT:BO LD {ON|OFF|<NR1>}
2-610 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
