To Next Page

To Previous Page

Commands listed in alphabetical order

SSPLIT speciﬁe

s Start (SSPLIT) (0) Start/Complete value.

Examples

SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:SC:VALUE DO NTCARE sets

the Start/Complete value for USB bus trigger search 1 to DONTCare.

SEARCH:SEARCH2:TRIGGER:A: BUS:USB:SPLIT:SC:VALUE? might return

:SEARCH:SEARCH2:TRIGGER:A :BUS:USB:SPLIT:SC:VALUE S SPLIT,

indicating that the Start/Complete value for USB bus trigger search 2 is set to

SSPLIT.

SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:SPLIT:SE:VALue

This command sets or queries the Start/End value for the speciﬁed USB bus

trigger on split token ﬁeld search to determine where to place a mark. The search

number is speciﬁed by <x>.

Conditions

Requires the SR-USB2 Serial Triggering and Analysis Application.

Group

Search and Mark

Syntax

SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SPLIT:SE:VALue

{NOCARE|FULLSPEED|ISOALL| ISOEND|ISOMID|ISOSTART|LOWSPEED}

SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SPLIT:SE:VALue?

Arguments

NOCARE speciﬁes Don’t Care (X) Start/End bit value.

FULLSPEED speciﬁes Control/Bulk/Interrupt Full Speed device (0X) Start/End

bit value.

ISOALL speciﬁes Isochronous Data is All (11) Start/End bit value.

ISOEND speciﬁes Isochronous Data is End (01) Start/End bit value.

ISOMID speciﬁes Isochronous Data is Middle (00) Start/End bit value.

ISOSTART speciﬁes Isochronous Data is Start (10) Start/End bit value.

LOWSPEED speciﬁes Control/Bulk/Interrupt Low Speed device (1X) Start/End

bit value.

Examples

SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:SE:VALUE IS OSTART sets

the Start/End value for USB bus trigger on split token ﬁeldsearch1toISOSTART.

SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:SE:VALUE? might return

:SEARCH:SEARCH1:TRIGGER:A :BUS:USB:SPLIT:SE:VALUE D ONTCARE,

2-712 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58