Commands listed in alphabetical order
FordIbydtmeas
urement, the parameter is “DIBYDT”.
For SOA measurement, the p arameter is “SOAHITSCNT”.
For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.
For Switching Ripple measurement, the parameters are “SWRIPRMS” |
“SWRIPPKPK”.
For Cycle Period measurement, the parameters is “PRIOD”.
For Cycle Frequency meas urement, the parameters is “FREQ”.
For Positive Duty Cycle measurement, the parameters is “PDUTY”.
For Negat
ive Duty Cycle measurement, the parameters is “NDUTY”.
For Positive Pulse Width measurement, the parameters is “PPULSE”.
For Negative Pulse Width measurement, the p arameters is “NPULSE”.
For Cycle Amplitude measurement, the parameters is “AMPL”.
For Cycle Peak–Peak measurement, the parameters is “PKPK”.
For Cycle Top measurement, the parameters is “HIGH”.
For Cy
cle Base measurement, the parameters is “LOW”.
For Cycle Max measurement, the parameters is “MAX”.
For Cycle Min measurement , the parameters is “MIN”.
Examples
POWer:POWer1:RESUlts:CURRe ntacq:PK2PK? “TONLoss” might return
9.91E+37, indicating the peak-to-peak value of Ton Energy for the current
acquisition.
POWer:POWer<x>:RESUlts:CURRentacq:POHCL? (Query Only)
This command queries the limit of partial odd harmonic current for the specified
power measurement badge. The power measurement badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:RESUlts:CUR Rentacq:POHCL? "harmonics"
MSO54, MSO56, MSO58, MSO58LP Programmer 2-575
To Next Page
Loading...
Need help?
General
