To Next Page

To Previous Page

Commands listed in alphabetical order

Group

Measurement

Syntax

MEASUrement:REF<x>:REFLeve ls:PERCent:FALLLow <NR3>

MEASUrement:REF<x>:REFLeve ls:PERCent:FALLLow?

Arguments

<NR3> is the percentage used to calculate the low reference level

Examples

MEASUrement:REF1:REFLevels :PERCent:FALLLow 5 sets the low reference

level to 5%.

MEASUrement:REF1:REFLevels :PERCent:FALLLow? might return

:MEASUREMENT:REF1:REFLEVEL S:PERCENT:FALLLOW 10.0000 indicating

the low reference level is 10%.

MEASUrement:REF<x>:REFLevels:PERCent:FALLMid

This command sets or queries the percentage (where 100% is equal to TOP and

0% is equal to BASE) used to calculate the mid reference level of the falling edge

when the measurement's ref level method is set to percent.

Group

Measurement

Syntax

MEASUrement:REF<x>:REFLeve ls:PERCent:FALLMid <NR3>

MEASUrement:REF<x>:REFLeve ls:PERCent:FALLMid?

Arguments

<NR3> is the percentage used to calculate the mid reference level of the falling

edge.

Examples

MEASUrement:REF1:REFLevels :PERCent:FALLMid 55 sets the reference

level to 50%.

MEASUrement:REF1:REFLevels :PERCent:FALLMid? might return

:MEASUREMENT:REF1:REFLEVEL S:PERCENT:FALLMID 50.0000 indicating

the mid reference level is 50%.

MEASUrement:REF<x>:REFLevels:PERCent:HYSTeresis

This command sets or queries the percentage (where 100% is equal to MAX and

0% is equal to MIN) used to calculate the hysteresis of the reference level when

the measurement's ref level method is set to percent.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-513

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58