Tektronix MSO58 User Manual

Commands listed in alphabetical order
MEASUrement:M
EAS1:REFLevels1:BASETop?
might return
:MEASUREMENT:MEAS1:REFLEV ELS1:BASETOP AUTO indicating the
instrument automatically chooses a reference level method.
MEASUrement
:MEAS<x>:REFLevels<x>:METHod
This command sets or queries the method used to calculate reference levels for the
measurement. The measurement number is specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:REFLe vels<x>:METHod {PERCent|ABSo lute}
MEASUrement:MEAS<x>:REFLe vels<x>:METHod?
Arguments
PERCent specifies that the reference levels are calculated as a percent
relative to HIGH and LOW. The percentages are defined using the
MEAS
Urement:MEAS<x>:REFLevel:PER Cent
commands.
ABSolute specifies that the reference levels are set explicitly using the
MEA
SUrement:MEAS<x>:REFLevel: ABSolute
commands. This method is
useful when precise values are required.
Examples
MEASUREMENT:MEAS1:REFLEVE LS1:METHOD ABSOLUTE specifies that explicit
user-defined values are used for the reference levels.
MEASUREMENT:MEAS1:REFLEVE LS1:METHOD? might return
:MEASUREMENT:MEAS1:REFLEV ELS1:METHOD PERCENT, i ndicating that the
reference level units used are calculated as a percent rela tive to HIGH and LOW.
MEASUrement:MEAS<x>:REFLevels<x>:PERCent:FALLHigh
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the high reference level of the falling edge
when the measurement's re f level method is set to percent. The measurement
number is specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:REFLe vels<x>:PERCent:FALLHigh <NR3>
MEASUrement:MEAS<x>:REFLe vels<x>:PERCent:FALLHigh?
2-474 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English