To Next Page

To Previous Page

Commands listed in alphabetical order

If the CAN stand

ard is set for ISO CAN FD or Non-ISO CAN FD, and the trigger

data size is set to 8, the maximum value for the data offset will be 56 (64 - 8 = 56).

TRIGger:{A|B}:BUS:B<x>:CAN:DATa:QUALiﬁer

This command sets the qualiﬁer(<,>,=,≠, ≤, ≥) to be used when triggering

on a CAN bus signal. The trigger condition must be set to IDANDDATA or

DATa (using TRIGger:{A|B}:BUS:B<x>:CAN:CONDition). The bus number is

speciﬁed b

y<x>.

Conditions

Requires the SR-AUTO Triggering and Analysis application.

Group

Trigger

Syntax

TRIGger:{A|B}:BUS:B<x>:CAN :DATa:QUALifier

{LESS

than|MOREthan|EQual|UNEQual |LESSEQual|MOREEQual}

TRIGger:{A|B}:BUS:B<x>:CAN :DATa:QUALifier?

Arguments

LESSthan sets the oscilloscope to trigger when the data is less than the qualiﬁer

value.

MOREthan sets the oscilloscope to trigger when the data is greater than the

qualiﬁer value.

EQual sets the oscilloscope to trigger when the data is equal to the qualiﬁer value.

UNEQual sets the oscilloscope to trigger when the data is not equal to the qualiﬁer

value.

LESSEQual sets the oscilloscope to trigger when the data is less than o r equal

to the qualiﬁer value.

MOREEQual sets the oscilloscope to trigger when the data is greater than or equal

to the qualiﬁer value.

Examples

TRIGGER:A:BUS:B1:CAN:DATA: QUALIFIER LESSTHAN sets the oscilloscope

to trigger when the data is less than the qualiﬁer value.

TRIGGER:A:BUS:B1:CAN:DATA: QUALIFIER? might return

:TRIGGER:A:BUS:B1:CAN:DATA :QUALIFIER LESSTHAN, indicating that the

oscilloscope is set to trigger when the data is less than the qualiﬁer value.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-773

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58