Commands listed in alphabetical order
MEASUrement:
MEAS<x>:PATTERNTYPe
This command sets or queries the pattern type for the meas urement. Measurements
are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:PATTE RNTYPe {REPeating|ARBitra ry}
MEASUrement:MEAS<x>:PATTE RNTYPe?
Arguments
REPeating specifies a repeating pattern.
ARBitrary specifies an arbitrary pattern.
Examples
MEASUrement:MEAS1:PATTERN TYPe ARBITRARY specifies an arbitrary pattern.
MEASUrement:MEAS1:PATTERN TYPe? might return
:MEASUREMENT:MEAS1:PATTER NTYPE REPEATING indicating a repeating
pattern.
MEASUrement:MEAS<x>:PERFREQ:EDGE
This command sets or queries the edge type of a Period/Frequency measurement.
The measurement number is specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:PERFR EQ:EDGE {FIRST|RISE|FALL}
Arguments
FIRST computes the measurement between Rising edges if the firstedgeisRising.
Computes the measurement between Falling edges if the first edge is Falling.
RISE computes the measurement between Rising edges.
FALL computes the measurement between Falling edges.
Examples
MEASUrement:MEAS1:PERFREQ :EDGE RISE specifies computing the
measurement between Rising edges.
measurement:meas1:perfreq :edge? might return
:MEASUREMENT:MEAS1:PERFRE Q:EDGE FIRST if the measurement
is computed between edges of the first type edge found.
2-466 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Need help?
General
