Commands listed in alphabetical order
Related Commands
DATa:SOUrce, W
FMOutpre:BN_Fmt, WFMOutpre:ENCdg
Returns
Returns the domain of the outgoing waveform.
Examples
WFMOUTPRE:DOMAIN? might return :WFMOUTPRE:DOMAIN TIME, indicating t hat
the outgoing waveform is time domain trace.
WFMOutpre:ENCdg
This command sets and queries the type of encoding for outgoing waveforms.
Group
Waveform Transfer
Syntax
WFMOutpre:ENCdg {ASCii|BINary}
WFMOutpre:ENCdg?
Related Commands
DATa:ENCdg, WFMOutpre:BYT_Nr, WFMOutpre:BYT_Or,
WFMOutpre:BIT_Nr, WFMOutpre:BN_Fmt
Arguments
ASCii specifies that the outgoing data is to be in ASCII format. Waveforms
internally stored as integers will be sent as <NR1> numbers, while those stored as
floating point will be sent as <NR3> numbers.
BINary specifies that outgoing data is to be in a binary format whose further
specification is determined by WFMOutpre:BYT_Nr, WFMOutpre:BIT_Nr,
WFMOutpre:BN_Fmt and WFMOutpre:BYT_Or.
Examples
WFMOUTPRE:ENCDG ASCii specifies that the outgoing waveform data will be
sent in ASCII format.
WFMOUTPRE:ENCDG? might return :WFMO UTPRE:ENCDG BINary, indicating that
outgoing waveform data will be sent in binary format.
WFMOutpre:NR_Pt? (Query Only)
This query-only command returns the number of points for the DATa:SOUrce
waveform that will be transmitted in response to a CURVe?query.
Group
Waveform Transfer
2-894 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
