Tektronix MSO58 User Manual

Commands listed in alphabetical order
INrange sets th
edataqualifier to in range.
OUTrange sets the data qualifier to out of range.
Examples
TRIGGER:A:BUS:B1:FLEXRAY: DATA:QUALIFIER LESSTHAN sets the data
qualifier to LESSTHAN.
TRIGGER:A:BUS:B1:FLEXRAY: DATA:QUALIFIER? might return
TRIGGER:A:BUS:B1:FLEXRAY: DATA:QUALIFIER EQUAL indicating the data
qualifier is EQUAL.
TRIGger:{A|B}:BUS:B<x>:FLEXray:DATa:SIZe
This command specifies the length of the data string, in bytes, when triggering
on the FlexRay bus data field. The trigger condition needs to be set to ID or
IDANDDATA (using TRIGger:{A|B}:BUS:B<x>:FLEXray:CONDition). The
bus number is specified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FL EXray:DATa:SIZe <NR1>
TRIGger:{A|B}:BUS:B<x>:FL EXray:DATa:SIZe?
Arguments
<NR1> is the FlexRay data string length, in bytes.
Examples
TRIGGER:A:BUS:B1:FLEXRAY: DATA:SIZE 8 sets the data string size to 8
bytes.
TRIGGER:A:BUS:B1:FLEXRAY: DATA:SIZE? might return
TRIGGER:A:BUS:B1:FLEXRAY: DATA:SIZE 1 indicating the data
size is 1 byte.
TRIGger:{A|B}:BUS:B<x>:FLEXray:DATa:VALue
This command specifies the low value when triggering on the FlexRay bus
data field. (Use TRIGger:{A|B}:BUS:B<x>:FLEXray:DATa:HIVALue to set
the upper value.) The trigger condition needs to be set to ID or IDANDDATA
(using TRIGger:{A|B}:BUS:B<x>:FLEXray:CONDition). The bus number is
specified by <x>.
2-798 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Analog Channels	8
Sample Rate	6.25 GS/s
Operating Temperature	0 °C to +50 °C
Bandwidth	2 GHz
Digital Channels	16
Record Length	125 Mpoints
Display	15.6 inch touchscreen
Waveform Update Rate	>500, 000 waveforms/s
Vertical Resolution	12 bits
Input Impedance	1 MΩ ±1%, 13 pF ±2 pF
Maximum Input Voltage	300 V (DC + AC peak)
Probe Interface	TekVPI
Dimensions	14.4 in x 8.7 in x 6.0 in