Tektronix MSO58 User Manual

Commands listed in alphabetical order
Examples
TRIGger:A:BUS
:B1:ETHERnet:TCPHeader:SOUrc eport:VALue
"XXXX000010100110"
would set the source port address that is to be used in the
trigger to hexadecima l X0A6.
TRIGger:A:BUS:B1:ETHERnet: TCPHeader:SOUrceport:VALue? might
return
"XXXXX01001010110".
TRIGger:{A
|B}:BUS:B<x>:FLEXray:CONDition
This command specifies the condition to use when triggering on a FlexRay bus
signal (start of frame, frame type, ID, cycle count, header, data, ID a nd data, EOF,
error). T
he bus number is specified by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FLE Xray:CONDition
{SOF|FRAMEType|IDentifier| CYCLEcount|HEADer|DATa
|IDANDDATA|EOF|ERRor}
TRIGger:{A|B}:BUS:B<x>:FLE Xray:CONDition?
Arguments
SOF sets the trigger condition to start of frame.
FRAMEType sets the trigger condition to frame type.
IDentifier sets the trigger condition to identifier.
CYCLEcount sets the trigger condition to cycle count.
HEADer sets the trigger condition to header.
DATa sets the trigger condition to data.
IDANDDATA sets the trigger condition to id a nd data.
EOF sets the trigger condition to end of frame.
ERRor sets the trigger condition to error.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:C ONDITION FRAMETYPE sets the FlexRay
condition to frame type.
TRIGGER:A:BUS:B1:FLEXRAY:C ONDITION? might return
TRIGGER:A:BUS:B1:FLEXRAY:C ONDITION SOF indicating the
FlexRay condition is start of frame.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-793

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English