Tektronix MSO58 User Manual

Commands listed in alphabetical order
TRIGger:{A|B
}:TRANsition:POLarity
This command specifies the polarity for the transition trigger.
Group
Trigger
Syntax
TRIGger:{A|B}:TRANsition:P OLarity {EITher|NEGative| POSitive}
TRIGger:{A|B}:TRANsition:P OLarity?
Arguments
POSitive indicates that a pulse edge must traverse from the lower (most
negative) to higher (most positive) level for transition triggering to occur.
NEGative indicates that a pulse edge must traverse from the upper (most positive)
to lower (most negative) level for transition triggering to occur.
EITher indicates either positive or negative polarity.
Examples
TRIGGER:A:TRANSITION:POLAR ITY NEGATIVE sets the transition polarity to
negative.
TRIGGER:A:TRANSITION:POLAR ITY? might return
:TRIGGER:A:TRANSITION:POLA RITY EITHER indicating that the polarity
can be either positive or negative.
TRIGger:{A|B}:TRANsition:SOUrce
This command specifi es the source waveform for a transition trigger.
NOTE. Digital channels are not supported as transition trigger sources.
Group
Trigger
Syntax
TRIGger:{A|B}:TRANsition:S OUrce {CH<x>}
TRIGger:{A|B}:TRANsition:S OUrce?
Arguments
CH<x> specifies one of the analog channels to be used as the source for a
transition trigger.
Examples
TRIGGER:A:TRA
NSITION:SOURCE CH4
sets channel 4 as the source for the
transition trigger.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-869

Tektronix MSO58 Specifications

General

Analog Channels	8
Sample Rate	6.25 GS/s
Operating Temperature	0 °C to +50 °C
Bandwidth	2 GHz
Digital Channels	16
Record Length	125 Mpoints
Display	15.6 inch touchscreen
Waveform Update Rate	>500, 000 waveforms/s
Vertical Resolution	12 bits
Input Impedance	1 MΩ ±1%, 13 pF ±2 pF
Maximum Input Voltage	300 V (DC + AC peak)
Probe Interface	TekVPI
Dimensions	14.4 in x 8.7 in x 6.0 in