Commands listed in alphabetical order
UNEQual search
es on an input value that is not equal to a set value.
Examples
SEARCH:SEARCH1:TRIGger:A:L OGIc:WHEn FALSE specifiesasearchonan
input value that is false.
SEARCH:SEARCH1:TRIGger:A:L OGIc:WHEn? might return
:SEARCH:SEARCH1:TRIGGER:A: LOGIC:WHEN T
RUE
indicating a search on an
input value that is true.
SEARCH:SEARCH<x>:TRIGger:A:PULSEWidth:HIGHLimit
This command specifi es the upper limit to use, in seconds, when searching for
a pulse whose duration is inside or outside a range of two values. The search
number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :PULSEWidth:HIGHLimit <NR 3>
SEARCH:SEARCH<x>:TRIGger:A :PULSEWidth:HIGHLimit?
Arguments
<NR3> is the upper limit to use, in seconds, when searching for a pulse.
Examples
SEARCH:SEARCH1:TRIGger:A:P ULSEWidth:HIGHLimit 2.5e- 9 sets the
high limit to 2.5 ns.
SEARCH:SEARCH1:TRIGger:A:P ULSEWidth:HIGHLimit? might return
:SEARCH:SEARCH1:TRIGGER:A: PULSEWIDTH:HIGHLIMIT 2.00 00E-9
indicating the pulse width high limit is 2.0 ns.
SEARCH:SEARCH<x>:TRIGger:A:PULSEWidth:LOGICQUALification
This command specifies whether or not to use logic qualification for a pulse width
search. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :PULSEWidth:LOGICQUALification
{ON|OFF}
SEARCH:SEARCH<x>:TRIGger:A :PULSEWidth:LOGICQUALification?
MSO54, MSO56, MSO58, MSO58LP Programmer 2-723
To Next Page
Need help?
General
