Commands listed in alphabetical order
MEASUrement:
MEAS<x>:PATTERNDETECTION
This command sets or queries the pattern detection type for the measurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:PATTER NDETECTION {AUTO|MANUAL}
MEASUrement:MEAS<x>:PATTER NDETECTION?
Arguments
AUTO automatically detects the pattern.
MANUAL requires manually detecting the pattern.
Examples
MEASUrement:MEAS1:PATTERND ETECTION MANUAL specifies manually
detecting the pattern.
MEASUrement:MEAS1:PATTERND ETECTION? might return
:MEASUREMENT:MEAS1:PATTERN DETECTION AUTO indicating
patterns are automatically detected.
MEASUrement:MEAS<x>:PATTERNLENgth
This command sets or queries the pattern length for the measurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:PATTER NLENgth <NR3>
MEASUrement:MEAS<x>:PATTER NLENgth?
Arguments
<NR3> is the pattern length.
Examples
MEASUrement:MEAS1:PATTERNL ENgth 3.0 sets the pattern length to 3.0.
MEASUrement:MEAS1:PATTERNL ENgth? might return
:MEASUREMENT:MEAS1:PATTERN LENGTH 2.0000 indicating the
patternlength is 2.0.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-465
To Next Page
Loading...
Need help?
General
