Tektronix MSO58 User Manual

Commands listed in alphabetical order
Syntax
TRIGger:{A|B}
:BUS:B<x>:USB:DATa:SIZe <NR1>
TRIGger:{A|B}:BUS:B<x>:USB :DATa:SIZe?
Arguments
<NR1> is number in the range 1 to 16.
Examples
TRIGGER:A:BUS:B1:USB:DATA: SIZE 4 sets the oscilloscope to trigger on four
contiguous data bytes.
TRIGGER:A:BUS:B1:USB:DATA: SIZE? might return
:TRIGGER:A:BUS:B1:USB:DATA :SIZE 6 indicating that the oscilloscope will
trigger on 6 contiguous data bytes.
TRIGger:{A|B}:BUS:B<x>:USB:DATa:TYPe
This command specifies the data type for a USB trigger. The bus number is
specified by <x>.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:USB :DATa:TYPe
{ANY|DATA0|DATA1|DATA2|MDA TA}
TRIGger:{A|B}:BUS:B<x>:USB :DATa:TYPe?
Related Commands
TRIGger:{A|B}:BUS:B<x>:USB:CONDition
Arguments
ANY indicates either a DATA0 or DATA1 data packet type.
DATA0 indicates a DATA0 data packet type.
DATA1 indicates a DATA1 data packet type.
DATA2 indicates a DATA2 data packet type when on HIGH speed.
MDATA indicates a MDATA data packet type when on HIGH speed.
Examples
TRIGGER:A:BUS:B1:USB:DATA: TYPE DATA0 sets the oscilloscope to trigger
on a DATA0 data packet type.
TRIGGER:A:BUS:B1:USB:DATA: TYPE? might return
:TRIGGER:A:BUS:B1:USB:DATA :TYPE DATA1, indicating that the data pa
cket
type is set to DATA1.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-839

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English