To Next Page

To Previous Page

Commands listed in alphabetical order

MEASUrement:

MEAS<x>:EDGES:LEVel

This sets or queries the level type for the 'time outside level' measurement.

Measurements are speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:EDGES :LEVel {HIGH|LOW|BOTH}

MEASUrement:MEAS<x>:EDGES :LEVel?

Arguments

HIGH speciﬁes the H IGH level.

LOW speciﬁes the LOW level.

BOTH speciﬁes both the HIGH and LOW level.

Examples

MEASUrement:MEAS1:EDGES:L EVel LOW sets the level to the low level.

MEASUrement:MEAS1:EDGES:L EVel? might return

:MEASUREMENT:MEAS1:EDGES: LEVEL HIGH indicating the level is set to

the high level.

MEASUrement:MEAS<x>:EDGES:LOWERFREQuency

This command sets o r queries the lower fre quency for the measurement when the

measurement type is phase noise. Lower frequencies are ignored. Measurements

are speciﬁed by x.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:EDGES :LOWERFREQuency <NR3>

MEASUrement:MEAS<x>:EDGES :LOWERFREQuency?

Arguments

<NR3> is the lower frequency of the edge.

Examples

MEASUrement:MEAS1:EDGES:L OWERFREQuency 1.0e3 sets the lower

frequencyto1kHz.

MEASUrement:MEAS1:EDGES:L OWERFREQuency? might return

:MEASUREMENT:MEAS1:EDGES: LOWERFREQUENCY 0.0E+0 i

ndicating the

lower frequency is set to 0.0 Hertz.

2-444 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58