Tektronix MSO58 User Manual

Commands listed in alphabetical order
TRIGger:A:BUS
:B1:PARallel:DATa:VALue
? might return
:TRIGGER:A:BUS:B1:PARALLEL :DATA:VALUE "X" indicating the data value
is X.
TRIGger:{A|
B}:BUS:B<x>:RS232C:CONDition
This command specifies the condition for an RS-232C trigger, where the bus
number is specified by< >x.
Conditions
Requires the SR-COMP Serial Triggering and Analysis Application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:RS2 32C:CONDition
{STARt|EOp|DATa|PARItyerro r}
TRIGger:{A|B}:BUS:B<x>:RS2 32C:CONDition?
Arguments
STARt sets the Trigger on condition to Start.
EOp sets the Trigger on condition to End of Packet.
DATa sets the Trigger on condition to Data.
PARItyerror sets the Trigger on condition to Parity Error.
Examples
TRIGger:A:BUS:B1:RS232C:CO NDition DATA sets the trigger on condition
to data.
TRIGger:A:BUS:B1:RS232C:CO NDition? might return
:TRIGGER:A:BUS:B1:RS232C:C ONDITION START indicating start
is the trigger condition.
TRIGger:{A|B}:BUS:B<x>:RS232C:DATa:SIZe
This command sets or queries the length of the data string in bytes to be used
for an RS-232C trigger when the trigger condition is Data. The bus number is
specified by <x>.
Conditions
Requires the SR-COMP Serial Triggering and Analysis Application.
Group
Trigger
MSO54, MSO56, MSO58, MSO58LP Programmer 2-831

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English