Tektronix MSO58 User Manual

Commands listed in alphabetical order
SEARCH:SEARCH
1:TRIGGER:A:BUS:ETHERNET:CON DITION?
might return
DATA, indicating that DATA is the currently specified field within an Ethernet
frame to search on.
SEARCH:SEAR
CH<x>:TRIGger:A:BUS:ETHERnet:DATa:HIVALue
This command sets or queries the binary data value to be used when searching on
an Ethernet bus signal. The search condition must be set to DATA and the data
qualifier t
o inside or outside range. The search number is specified by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:ETHERnet:DATa:HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:ETHERnet:DATa:HIVALue?
Arguments
<QString> is the binary data value to be used when searching on an Ether net
bus signal.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:ETHERnet:DATa:HIVALue “101011”
sets the data HIVALue to 1010 11.
SEARCH:SEARCH1:TRIGger:A: BUS:ETHERnet:DATa:HIVALue? might
return
:SEARCH:SEARCH1:TRIGGER
:A:BUS:ETHERNET:DATA:HIVALUE
"10101"
.
SEARCH:SEARCH<x>:TRIGger:A:BUS:ETHERnet:DATa:OFFSet
This command specifies the data offset value, in bytes, to use when searching on
the Ethernet data field. The search condition n eeds to be set to
DATa.Thesearch
number is specified by <x>.
Conditions
Requires the SR-ENET Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:ETHERnet:DATa:OFFSet <NR1>
SEARCH:SEARCH<x>:TRIGger: A:BUS:ETHERnet:DATa:OFFSe
t?
2-650 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English