Tektronix MSO58 User Manual

Commands listed in alphabetical order
MEASUrement:
MATH<x>:REFLevels:PERCent:FALLHigh
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the high reference level of the falling
edge when the
measurement ref level method is se t to percent. The math number
is specified by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLe vels:PERCent:FALLHigh <NR 3>
MEASUrement:MATH<x>:REFLe vels:PERCent:FALLHigh?
Arguments
<NR3> is the percentage (where 100% is equal to HIGH) used to calculate the
high reference level when the measurement Ref level method is set to Perce nt.
Examples
MEASUrement:MATH2:REFLeve ls:PERCent:FALLHigh 95 sets the reference
level to 95% of TOP.
MEASUrement:MATH2:REFLeve ls:PERCent:FALLHigh? might return
:MEASUREMENT:MATH2:REFLEV ELS:PERCENT:FALLHIGH 90.0 000
indicating the reference level is set to 90% of TOP.
MEASUrement:MATH<x>:REFLevels:PERCent:FALLLow
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to B ASE) used to calculate the low reference level of the falling
edge when the measureme nt ref level method is set to percent. The math number
is specified by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLe vels:PERCent:FALLLow <NR3 >
MEASUrement:MATH<x>:REFLe vels:PERCent:FALLLow?
Arguments
<NR3> is the percentage (where 100% is equal to HIGH) used to calculate the mid
reference level when the measurement's R ef level method is set to Percent.
Examples
MEASUrement:MATH2:REFLeve ls:PERCent:FALLLow 5 sets the reference
level to 5% of TOP.
2-416 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English