To Next Page

To Previous Page

Commands listed in alphabetical order

Syntax

POWer:POWer<x

>:RESUlts:ALLAcqs:MAXimum?

Arguments

<QString> = parame ters of the measurements. The details of the p arameters for

the Power measurements are listed below:

For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"

"VCFACTOR" | "IRMS" | "VRMS".

For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"

"TTLENRG".

For dV by dt m easurement, the parameter is “DVBYDT”.

For dI by dt measurement, the parameter is “DIBYDT”.

For SOA measurement, the parameter is “SOAHITSCNT”.

For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.

For Swi

tching Ripple measurement, the parameters a re “SWRIPRMS” |

“SWRIPPKPK”.

For Cy

cle Period measurement, the parameters is “PRIO D”.

For Cycle Frequency measurement, the parameters is “FREQ”.

For Positive Duty Cycle measurement, the parameters is “PDUTY”.

For Negative Duty Cycle measurement, the para meters is “NDUTY”.

For Positive Pulse Width measurement, the parameters is “PPULSE”.

For Negative Pulse Width measurement, the parameters is “NPULSE”.

r C ycle Amplitude measurement, the parameters is “AMPL”.

For Cycle Peak–Peak measurement, the parameters is “PKPK”.

For Cycle Top measurement, the parameters is “HIGH”.

For Cycle Base measurement, the parameters is “LOW”.

For Cycle Max measurement, the parameters is “MAX”.

For Cycle Min measurement, the parameters is “MIN”.

Examples

POWer:POWer1:RESUlts:CURR entacq:MAXimum? "TONEnrg" might return

9.91E+37, indicating the maximum value of Ton Energy for all acquisitions.

2-562 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58