Tektronix MSO58 User Manual

Commands listed in alphabetical order
The *RST comman
d does not change the following:
The current working d irectory (:FILESystem:CWD command).
The state of command headers (:HE ADer command).
The state of keyword and enumeration verbosity (:VERBose command).
The Power-on Status Clear Flag (*PSC command).
The Event Status Enable Register (*ESE command).
The Servic
e Request Enable Register (
*SRE command).
The Device Event Status Enable Register (DESE command).
The user password for protected user data (:PASSWord command).
The content of protected user data (*PUD command).
The enabled state of the socket server (:SOCKETServer:ENAble command).
The socket server port number (:SOCKETServer:PORT command).
The soc
ket server protocol (
:SOCKETServer:PROTOCol command).
The USBTMC port configuration (:USBDevice:CONFigure command).
The destination reference waveform or file path for the :CURVe command
(
:DATa:DESTination command).
Thesourcewaveformforthe :CURVe? or :WAVFrm? queries
(
:DATa:SOUrce command).
The waveform data encoding for the :CURVe command or query or the
:WAVFrm? query (:DAT a:ENCdg command).
The starting point for :CURVe? queries ( :DATa:STARt command).
The ending point for : CURVe? queries (:DATa:STOP comma nd).
All settings associated the : WFMInpre commands.
All user settable settings associated with the :WFMO utpre commands.
*
RST only resets the programmable interface settings, it does n ot change the
user interface settings.
Group
Status and Error
Syntax
*RST
Related Commands
FACtory, RECAll:SETUp
2-616 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English