6-7
FUEL
Fuel system
Fuel system
Reducing the fuel pressure
Before servicing the high-pressure fuel
line or vapor separator, make sure to
reduce the fuel pressure in the fuel line.
Otherwise, pressurized fuel could spray
out.
1. Remove the fuse cover 1, and then
remove the fuse (15 A) 2.
2. Start the engine and wait until the engine
stalls.
3. Crank the engine 2 or 3 times.
4. Turn the engine start switch to OFF.
5. Install the fuse (15 A), and then install the
fuse cover.
Disconnecting the quick connector
Before disconnecting the quick connec-
tor, reduce the fuel pressure. Otherwise,
pressurized fuel could spray out.
1. Reduce the fuel pressure. See “Reduc-
ing the fuel pressure” (6-7).
2. Remove the flywheel magnet cover.
3. Wrap a rag around the quick connector
1.
4. Spread apart the ends of the locking
slider a, and then move the locking
slider to the unlock position.
5. Disconnect the quick connector 1 from
the fuel rail or vapor separator.
1
2
a
1
1
PORT
STBD
1
a
To Next Page
Loading...
Need help?
General
