Cisco NCS 2000 series Troubleshoot Manual

This condition is only reported if the SNCP is set up for revertive switching.
Note
Clear the AUTOSW-LOP-SNCP Alarm
SUMMARY STEPS
1. Complete the Clear the AU-LOP Alarm , on page 130 procedure.
DETAILED STEPS
Complete the Clear the AU-LOP Alarm , on page 130 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-PDI
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STSMON, VT-MON
The Automatic Path Protection Switch Caused by Payload Defect Indication (PDI) condition indicates that
automatic path protection switching occurred because of a PDI-P , on page 352 alarm. If the path protection
is configured for revertive switching, it reverts to the working path after the fault clears.
This condition is only reported if the path protection is set up for revertive switching.
Note
Clear the AUTOSW-PDI Condition
SUMMARY STEPS
1. Complete the Clear the PDI-P Condition, on page 353 procedure.
DETAILED STEPS
Complete the Clear the PDI-P Condition, on page 353 procedure.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
136
Alarm Troubleshooting
Clear the AUTOSW-LOP-SNCP Alarm

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English