• SF (TRUNK) , on page 390 alarm
Clear the ILK-FAIL Alarm
SUMMARY STEPS
1. Clear the root-cause service-affecting alarm by using one of the following procedures, as appropriate:
DETAILED STEPS
Clear the root-cause service-affecting alarm by using one of the following procedures, as appropriate:
• Clear the LOS (TRUNK) Alarm, on page 279 procedure
• Clear the LOF (TRUNK) Alarm, on page 265 procedure
• Clear the SF (TRUNK) Condition, on page 390 procedure
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into http://www.cisco.com/c/
en/us/support/web/tsd-cisco-worldwide-contacts.html to obtain a directory of toll-free Technical Support numbers for
your country.
IMPROPRMVL
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Objects: EQPT, PPM
The Improper Removal (IMPROPRMVL) alarm occurs under the following conditions:
• A card is removed when the card was rebooting. It is recommended that after the card completely reboots,
delete the card in CTC and only then remove the card physically. When you delete the card, CTC loses
connection with the node view (single-shelf mode) or shelf view (multishelf mode), and goes to network
view.
• When a card is deleted from CTC before physically removing the card from its slot. It is recommended
that the card be physically removed from its slot before deleting it from CTC.
CTC provides the user approximately 15 seconds to physically remove the card
before it begins rebooting the card.
It can take up to 30 minutes for software to be updated on a standby control card.
Note
• A card is inserted into a slot but is not fully plugged into the backplane.
• A PPM (SFP) is provisioned but the physical module is not inserted into the port.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
235
Alarm Troubleshooting
Clear the ILK-FAIL Alarm
To Next Page
Loading...
Need help?
General
