Cisco NCS 2000 series Troubleshoot Manual

Clear the LPBKTERMINAL (ESCON) Condition
SUMMARY STEPS
1. Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
455 procedure.
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
LPBKTERMINAL (FC)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: FC
A Loopback Terminal condition for the FC payload occurs on an FC when a software terminal (inward)
loopback is active for an MXP_MR_2.5G, MXPP_MR_2.5G, TXP_MR_2.5G, TXPP_MR_2.5G, GE-XP,
and 10GE-XP card client PPM (SFP) provisioned at the FC1G, FC2G, FICON1G, or FICON2G line speed.
For information about troubleshooting these circuits with loopbacks, refer to the Troubleshooting MXP, TXP,
XP, or ADM-10G Circuit Paths With Loopbacks, on page 7 section.
Clear the LPBKTERMINAL (FC) Condition
SUMMARY STEPS
1. Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
455 procedure.
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
296
Alarm Troubleshooting
Clear the LPBKTERMINAL (ESCON) Condition

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English