Cisco NCS 2000 series Troubleshoot Manual

DETAILED STEPS
Complete the Clear the RS-EOC Alarm, on page 381 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
MS-EXC
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STM1E
The Multiplex Section Signal Excessive BER condition is similar to the SDBER-EXCEED-HO , on page 388
alarm, but applies only to the multiplex section overhead of the EQPT object.
Clear the MS-EXC Condition
SUMMARY STEPS
1. Complete the Clear the SDBER-EXCEED-HO Condition, on page 389 procedure.
DETAILED STEPS
Complete the Clear the SDBER-EXCEED-HO Condition, on page 389 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
MS-RFI
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: STM1E, STMN
The MS Remote Fault Indication (RFI) condition indicates that there is an RFI occurring at the SONET
overhead multiplexing section level.
An RFI occurs when the NCS detects an RFI in the SONET overhead because of a fault in another node.
Resolving the fault in the adjoining node clears the MS-RFI condition in the reporting node.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
308
Alarm Troubleshooting
MS-EXC

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English