Cisco NCS 2000 series Troubleshoot Manual

• MAN-REQ (for an ML-Series object)
• RPR-SF
• RPR-SD
• WTR (for an ML-Series object)
Clear the FORCED-REQ Condition
SUMMARY STEPS
1. Complete the Clear a 1+1 Force or Manual Switch Command, on page 445 procedure.
2. If the condition is raised on an IEEE 802.17b-based RPR span, enter the following command in the CLI
in RPR-IEEE interface configuration mode:
DETAILED STEPS
Step 1 Complete the Clear a 1+1 Force or Manual Switch Command, on page 445 procedure.
Step 2 If the condition is raised on an IEEE 802.17b-based RPR span, enter the following command in the CLI in RPR-IEEE
interface configuration mode:
router(config-if)#no rpr-ieee protection request force-switch {east | west}
If the troubleshooting procedure does not clear the alarm, log into the Technical Support Website at http://www.cisco.com/
c/en/us/support/index.html or call the Cisco Technical Assistance Center (1 800 553-2447) to report the problem.
FORCED-REQ-SPAN (2R, ESCON, FC, GE, ISC, OCN/STMN, OTS)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Objects: 2R, ESCON, FC, GE, ISC, OCN/STMN, OTS
The Force Switch Request Span condition applies to Y-cable-protected TXP configurable clients (OC-3,
OC-12/STM-4,OC-48/STM-16, OC-192/STM-64, FC, ESCON, or FICON). If traffic is present on a working
port and you use the FORCE command to prevent it from switching to the protect port (indicated by FORCED
TO WORKING), FORCED-REQ-SPAN indicates this force switch. In this case, the force is affecting not
only the facility, but the span.
For more information about protection schemes, refer to the Manage the Node document.
Note
FORCED-REQ-SPAN (TRUNK)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
204
Alarm Troubleshooting
Clear the FORCED-REQ Condition

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English