Cisco NCS 2000 series Troubleshoot Manual

If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-PDI-SNCP
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: VCMON-HP, VCMON-LP
The Automatic UPSR Switch Caused by Payload Defect Indication (PDI) condition indicates that automatic
UPSR protection switching occurred because of a PDI alarm. If the UPSR is configured for revertive switching,
it reverts to the working path after the fault clears.
This condition is only reported if the SNCP is set up for revertive switching.
Note
Clear the AUTOSW-PDI-SNCP Condition
SUMMARY STEPS
1. Complete the Clear the PDI-P Condition, on page 353 procedure.
DETAILED STEPS
Complete the Clear the PDI-P Condition, on page 353 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-SDBER
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STSMON, VT-MON
The Automatic Path Protection Switch Caused by Signal Degrade Bit Error Rate (SDBER) condition indicates
that a SD-P , on page 387 condition caused automatic path protection switching to occur. If the path protection
is configured for revertive switching, the path protection reverts to the working path when the SD-P is resolved.
This condition is only reported if the path protection is set up for revertive switching.
Note
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
137
Alarm Troubleshooting
AUTOSW-PDI-SNCP

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English