Cisco NCS 2000 series Troubleshoot Manual

a) In card view, click the Provisioning > EFM > Configuration tabs.
b) From the EFM State drop-down list, choose Enabled.
c) Click Apply to enable EFM for that port.
Peer port is in IS state.
EFM-RFI-CE
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: GE
The EFM Remote Failure Indication Critical Event (EFM-RFI-CE) alarm is raised if the peer interface defines
the RFI CE.
Clear the EFM-RFI-CE Alarm
SUMMARY STEPS
1. Cisco devices do not generate RFI CE events. If a non-Cisco peer device generates an RFI CE event, a
Cisco device can raise the EFM-RFI-CE alarm. Check the scenarios under which the non Cisco peer
device generates the RFI CE and then clear the condition that lead to the RFI CE.
DETAILED STEPS
Cisco devices do not generate RFI CE events. If a non-Cisco peer device generates an RFI CE event, a Cisco device can
raise the EFM-RFI-CE alarm. Check the scenarios under which the non Cisco peer device generates the RFI CE and then
clear the condition that lead to the RFI CE.
EFM-RFI-DG
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: GE
The EFM Remote Failure Indication Dying Gasp alarm indicates one of the following:
• The peer interface is administratively shut down.
• The EFM is not configured on the peer interface.
• The peer card is reloading.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
171
Alarm Troubleshooting
EFM-RFI-CE

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English