Cisco NCS 2000 series Troubleshoot Manual

Step 7 If the condition does not clear, clean the far-end optical fiber according to site practice. If no site practice exists, complete
the procedure in the Maintain the Node chapter of the Configuration guide.
Step 8 If the condition does not clear, complete the Physically Replace a Card, on page 453 procedure for the optical/electrical
cards.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
PEER-CERT-VERIFICATION-FAILED
Default Severity: Major (MJ), Non-Service-Affecting (NSA)
Logical Object: OTN
The Peer Certificate Verification Failed alarm is raised when the verification of a peer certificate in the card
fails.
Clear the PEER-CERT-VERIFICATION-FAILED Alarm
This alarm is cleared when the verification of a peer certificate in the card is pass.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
PEER-CSF
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: STM/OCN
The Peer Client Signal Fail alarm that is a secondary alarm raised on local OCN, OTU1, or SDI_3G_VIDEO
ports when a remote Service-Affecting (SA) alarm causes an invalid data transmission. The alarm is raised
locally on AR_MXP and AR_XP ports and does not indicate that a Service-Affecting (SA) failure has occured
at the local site. Instead it indicates that an alarm such as LOS, LOS-P, LOF, OTU-AIS is caused by an event
affecting the transmission capability of the remote port.
Clear the PEER-CSF Alarm
SUMMARY STEPS
1. Clear the Service-Affecting (SA) alarm at the remote data port.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
354
Alarm Troubleshooting
PEER-CERT-VERIFICATION-FAILED

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English