Cisco NCS 2000 series Troubleshoot Manual

If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
OCHTERM-INC
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: OCHTERM
The Optical Termination Incomplete condition is raised against an OCH termination of there is no peer OCH
termination at the other end of a span.
Clear the OCHTERM-INC Condition
SUMMARY STEPS
1. Create an OCH termination at the other end of the span. For procedures to do this, refer to the Configuration
guide.
DETAILED STEPS
Create an OCH termination at the other end of the span. For procedures to do this, refer to the Configuration guide.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
ODUK-1-AIS-PM
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: TRUNK
The ODUK-1-AIS-PM is a secondary condition raised on MXP and ADM-10G cards trunk signals when they
experience an LOS (2R). Although the ODUK-1-AIS-PM is raised against the TRUNK object, it actually
refers to the client signals contained within the trunk.
A single ODUK-x-AIS-PM can occur when one far-end client signal is lost; multiple ODK-x-AIS-PMs can
occur (ODUK-1-AIS-PM, ODUK-2-AIS-PM, ODUK-3-AIS-PM, ODUK-4-AIS-PM) if more than one far-end
client is lost. If the entire trunk signal is lost, LOS (TRUNK) occurs and demotes any LOS (2R) alarms.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
314
Alarm Troubleshooting
OCHTERM-INC

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English