network issue persists, you must contact network lab support. If the condition is caused by a network element
(NE) failure, contact the Cisco Technical Assistance Center (TAC) (1 800 553-2447) for assistance.
EXERCISING-RING
The Exercising Ring Successfully (EXERCISING-RING) condition occurs whenever you issue an Exercise
Ring command from CTC or TL1. This condition indicates that a command is being executed.
EXERCISING-SPAN
The Exercising Span Successfully (EXERCISING-SPAN) condition occurs whenever you issue an Exercise
Span command from CTC or TL1. This condition indicates that a command is being executed.
FIREWALL-DIS
The Firewall Has Been Disabled (FIREWALL-DIS) condition occurs when you provision the firewall to
Disabled.
This transient condition does not result in a standing condition.
FIRMWARE-DOWNLOAD
The Firmware Download (FIRMWARE-DOWNLOAD) condition occurs when the firmware is being
downloaded during the firmware upgrade. The firmware upgrade initiates when the download is complete.
This transient condition does not result in a standing condition.
FIRMWARE-UPG
The Firmware Upgrade (FIRMWARE-UPG) condition occurs when the firmware is being upgraded. This
condition reflects the upgrade status.
This transient condition does not result in a standing condition.
FIRMWARE-UPG-COMPLETE
The Firmware Upgrade Complete (FIRMWARE-UPG-COMPLETE) condition occurs when the firmware
upgrade is successfully completed.
This transient condition does not result in a standing condition.
FIRMWARE-UPG-FAIL
The Firmware Upgrade Fail (FIRMWARE-UPG-FAIL) condition occurs when the firmware upgrade fails.
The user must start the firmware upgrade again.
This transient condition does not result in a standing condition.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
471
Transient Conditions
EXERCISING-RING
To Next Page
Loading...
Need help?
General
