Cisco NCS 2000 series Troubleshoot Manual

The WAN-SYNCLOSS condition is raised when GE-Syncloss condition is detected on a STS payloads
(STS-192c).
Clear the WAN-SYNCLOSS Condition
SUMMARY STEPS
1. Set a valid GE frame and payload inside the affected STS.
DETAILED STEPS
Set a valid GE frame and payload inside the affected STS.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into http://www.cisco.com/c/
en/us/support/web/tsd-cisco-worldwide-contacts.html to obtain a directory of toll-free Technical Support numbers for
your country.
WKSWPR (2R, EQPT, ESCON, FC, GE, ISC, OTS)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Objects: 2R, EQPT, ESCON, FC, GE, ISC, OTS
This condition is raised when you use the FORCE SPAN, FORCE RING, or MANUAL SPAN command at
for a Y-Cable-protected MXP or TXP client port (set for one the above-listed client configurations). WKSWPR
is visible on the network view Alarms, Conditions, and History tabs.
This condition is raised when traffic is manually or automatically switched from the working to the protect
path on the 200G-CK-LC card. Reset the control card to clear the WKSWPR alarm.
For more information about protection schemes, refer to the Manage the Node document.
Note
WKSWPR (TRUNK)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: TRUNK
This condition is raised when you use the FORCE SPAN, FORCE RING, or MANUAL SPAN command at
for a splitter-protection enabled MXP or TXP trunk port. WKSWPR is visible on the network view Alarms,
Conditions, and History tabs.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
435
Alarm Troubleshooting
Clear the WAN-SYNCLOSS Condition

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English