Cisco NCS 2000 series Troubleshoot Manual

Clear the AUTOSW-SFBER-SNCP Condition
SUMMARY STEPS
1. Complete the Clear the SF (TRUNK) Condition, on page 390 procedure.
DETAILED STEPS
Complete the Clear the SF (TRUNK) Condition, on page 390 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-UNEQ (STSMON)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STSMON
The Automatic Path Protection Switch Caused by Unequipped condition indicates that an UNEQ-P , on page
423, caused automatic path protection switching to occur. If the path protection is configured for revertive
switching, it reverts to the working path after the fault clears.
This condition is only reported if the path protection is set up for revertive switching.
Note
Clear the AUTOSW-UNEQ (STSMON) Condition
SUMMARY STEPS
1. Complete the Clear the UNEQ-P Alarm, on page 424 procedure.
DETAILED STEPS
Complete the Clear the UNEQ-P Alarm, on page 424 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
140
Alarm Troubleshooting
Clear the AUTOSW-SFBER-SNCP Condition

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English