Cisco NCS 2000 series Troubleshoot Manual

WRMRESTART
The Warm Restart (WRMRESTART) condition occurs when the node restarts while it is powered up. A restart
can be caused by provisioning, such as a database restore or IP changes, or by software defects. A
WRMRESTART is normally accompanied by MANRESET or AUTORESET to indicate whether the reset
was initiated manually (MAN) or automatically (AUTO).
This is the first condition that appears after a control card is powered up. The condition changes to
COLD-START if the control card is restarted from a physical reseat or a power loss.
WTR-SPAN
The Span is in Wait To Restore State (WTR-SPAN) condition occurs when a BLSR or MS-SPRing switches
to another span due to a Signal Failure-Span command or a fiber is pulled from a four-fiber BLSR/MS-SPRing
configuration. The condition is raised until the WaitToRestore (WTR) period expires.
This transient condition clears when the BLSR/MS-SPRing returns to a normal condition or the IDLE state.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
477
Transient Conditions
WRMRESTART

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English