Cisco NCS 2000 series Troubleshoot Manual

DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
LPBKTERMINAL (TRUNK)
Default Severity: Not Alarmed (NA), Non-Service Affecting (NSA)
Logical Object: TRUNK
A Loopback Terminal condition on MXP or TXP trunk card indicates that there is an active terminal (inward)
loopback on the port.
For information about troubleshooting, refer to the Troubleshooting MXP, TXP, XP, or ADM-10G Circuit
Paths With Loopbacks, on page 7 section.
Clear the LPBKTERMINAL (TRUNK) Condition
SUMMARY STEPS
1. Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
455 procedure.
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455 procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
LSC-NOT-PRESENT-MIC-IN-USE
Default Severity: Major (MJ), Non-Service-Affecting (NSA)
Logical Object: EQPT
The LSC Not Present Mic In Use alarm is raised when the LSC is not present, and use LSC option is checked
in CTC.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
298
Alarm Troubleshooting
LPBKTERMINAL (TRUNK)

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English