Cisco NCS 2000 series Troubleshoot Manual

DETAILED STEPS
For the alarmed 40MUX, 32WSS-O, 40WSSC-C, 32DMX, or 40DMX card, complete the Physically Replace a Card,
on page 453 procedure.
High-performance devices on this card can get hot during operation. To remove the card, hold it by the
faceplate and bottom edge. Allow the card to cool before touching any other part of it or before placing
it in an antistatic bag. Statement 201
Warning
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into http://www.cisco.com/c/
en/us/support/web/tsd-cisco-worldwide-contacts.html to obtain a directory of toll-free Technical Support numbers for
your country.
AWG-OVERTEMP
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: OTS
The AWG Over Temperature alarm is raised if a 40MUX, 32WSS-O, 40WSSC-C, 32DMX, or 40DMX card
having an AWG-FAIL alarm is not replaced and its heater-control circuit temperature exceeds 212 degrees
F (100 degrees C). The card goes into protect mode and the heater is disabled.
Clear the AWG-OVERTEMP Alarm
SUMMARY STEPS
1. Complete the Clear the AWG-FAIL Alarm, on page 142 procedure.
DETAILED STEPS
Complete the Clear the AWG-FAIL Alarm, on page 142 procedure.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into http://www.cisco.com/c/
en/us/support/web/tsd-cisco-worldwide-contacts.html to obtain a directory of toll-free Technical Support numbers for
your country.
AWG-WARM-UP
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: OTS
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
143
Alarm Troubleshooting
AWG-OVERTEMP

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English