Cisco NCS 2000 series Troubleshoot Manual

Clear the MS-RFI Condition
SUMMARY STEPS
1. Log into the far-end node of the reporting NCS.
2. Determine whether there are other alarms, especially the LOS(STM1E, STMN).
3. Clear the main alarm. See the appropriate alarm section in this chapter for the procedure.
DETAILED STEPS
Step 1 Log into the far-end node of the reporting NCS.
Step 2 Determine whether there are other alarms, especially the LOS(STM1E, STMN).
Step 3 Clear the main alarm. See the appropriate alarm section in this chapter for the procedure.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
MT-OCHNC
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: OTS
The MT-OCHNC condition occurs when the user provisions (tunes) a specific wavelength for maintenance
on a WXC card from an input port (EXP1-8, ADD-RX) to the output port (COM-TX).
Clear the MT-OCHNC Condition
SUMMARY STEPS
1. Delete the provisioned wavelength that was specifically tuned for maintenance purposes on a WXC card.
DETAILED STEPS
Delete the provisioned wavelength that was specifically tuned for maintenance purposes on a WXC card.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
NO-SHARED-CIPHERS Alarm
Default Severity: Major (MJ), Service Affecting (SA)
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
309
Alarm Troubleshooting
Clear the MS-RFI Condition

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English