DETAILED STEPS
Clear the Service-Affecting (SA) alarm at the remote data port.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
PEER-NORESPONSE
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: EQPT
The switch agent raises a Peer Card Not Responding alarm if either traffic card in a protection group does not
receive a response to the peer status request message. PEER-NORESPONSE is a software failure and occurs
at the task level, as opposed to a communication failure, which is a hardware failure between peer cards.
Clear the PEER-NORESPONSE Alarm
SUMMARY STEPS
1. Complete the Reset a Card in CTC, on page 449 procedure for the reporting card.
2. Verify that the reset is complete and error-free and that no new related alarms appear in CTC. Verify the
LED appearance: A green ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates
a standby card.
DETAILED STEPS
Step 1 Complete the Reset a Card in CTC, on page 449 procedure for the reporting card.
Step 2 Verify that the reset is complete and error-free and that no new related alarms appear in CTC. Verify the LED appearance:
A green ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates a standby card.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
PMD-DEG
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: Trunk port (dir RX)
The PMD Degrade alarm is raised when the device experiences PMD in excess of 11ps for 40ME-MXP-C
and 40-ME-TXP-C cards, 30ps for 40E-MXP-C and 40E-TXP-C cards, and 180ps for 100G-LC-C cards and
100G-ME-C cards.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
355
Alarm Troubleshooting
PEER-NORESPONSE
To Next Page
Loading...
Need help?
General
