Cisco NCS 2000 series Troubleshoot Manual

Clear the LSC-NOT-PRESENT-MIC-IN-USE Alarm
Install LSC if use MIC or use LSC option is checked in CTC.
If the condition does not clear, log into the Technical Support Website at http://www.cisco.com/c/en/us/support/index.html
for more information or call Cisco TAC (1 800 553-2447).
LWBATVG
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: PWR
The Low Voltage Battery alarm occurs in a 48 VDC environment when a battery lead input voltage falls
below the low power threshold. This threshold, with a default value of 44 VDC, is user-provisionable. The
alarm remains raised until the voltage remains above the threshold for 120 seconds. (For information about
changing this threshold, refer to the Turn Up Node chapter in the Configuration guide.
Clear the LWBATVG Alarm
SUMMARY STEPS
1. The problem is external to the NCS system. Troubleshoot the power source supplying the battery leads.
DETAILED STEPS
The problem is external to the NCS system. Troubleshoot the power source supplying the battery leads.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into http://www.cisco.com/c/
en/us/support/web/tsd-cisco-worldwide-contacts.html to obtain a directory of toll-free Technical Support numbers for
your country.
MAN-LASER-RESTART
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Objects: OTS, AOTS
The Manual Laser Restart condition is raised when a ALS mode is set to Manual Restart or Manual Restart
for test.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
299
Alarm Troubleshooting
Clear the LSC-NOT-PRESENT-MIC-IN-USE Alarm

Cisco NCS 2000 series Specifications

General

Brand	Cisco
Model	NCS 2000 series
Category	Network Hardware
Language	English