Cisco Nexus 3548 User Manual

102
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
default-information originate (EIGRP)
default-information originate (EIGRP)
To generate a default route into the Enhanced Interior Gateway Routing Protocol (EIGRP), use the
default-information originate command. To disable this feature, use the no form of this command.
default-information originate [always] [route-map map-name]
no default-information originate
Syntax Description
Command Default Disabled
Command Modes Address-family configuration mode
Router configuration mode
Router VRF configuration mode
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to originate a default route (0.0.0.0/0) to all routes that pass the Condition route
map:
switch# configure terminal
switch(config)# router eigrp 201
switch(config-router)# address-family ipv4 unicast
switch(config-router-af)# default-information originate route-map Condition
switch(config-router-af)#
Related Commands
always (Optional) Generates the default route if the route is not in the EIGRP
routing information base.
route-map map-name (Optional) Generates the default route only if the route is permitted by the
route map. The map name is an alphanumeric string of up to 63 characters.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
address-family Enters address-family configuration mode.
copy running-config
startup-config
Saves the configuration changes to the startup configuration file.
default-metric Sets the metric for routes redistributed into EIGRP.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back