Cisco Nexus 3548 User Manual

499
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Show Commands
show ip rip interface
show ip rip interface
To display interface entry information from the Routing Information Protocol (RIP) topology table, use
the show ip rip interface command in any mode.
show ip rip interface [type slot/port] [vrf vrf-name]
Syntax Description
Command Default This command has no default settings.
Command Modes Any command mode
Command History
Examples This example shows how to display the neighbor information for a specified interface from the RIP
topology table:
switch(config-if)# show ip rip interface ethernet 1/2
Related Commands
interface type slot/port (Optional) Specifies the interface.
vrf vrf-name (Optional) Specifies the name of the virtual routing and forwarding (VRF)
instance. The vrf-name argument can be specified as any case-sensitive,
alphanumeric string up to 32 characters. The strings “default” and “all” are
reserved VRF names.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
show ip rip Displays RIP information.
show ip rip neighbor Displays RIP neighbor information.
show ip rip policy statistics Displays RIP policy statistics.
show ip rip route Displays RIP route information.
show ip rip statistics Displays RIP statistics.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back