346
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
set metric-type
set metric-type
To set the metric type for the destination routing protocol, use the set metric-type command. To return
to the default, use the no form of this command.
set metric-type {internal | type-1 | type-2}
no set metric-type {internal | type-1 | type-2}
Syntax Description
Command Default This command is disabled by default.
Command Modes Route-map configuration mode
Command History
Usage Guidelines Use the route-map global configuration command with match and set route-map configuration
commands to define the conditions for redistributing routes from one routing protocol into another. Each
route-map command has a list of match and set commands associated with it. The match commands
specify the match criteria—the conditions under which redistribution is allowed for the current
route-map command. The set commands specify the set actions—the particular redistribution actions
to perform if the criteria enforced by the match commands are met. The no route-map command deletes
the route map.
The set route-map configuration commands specify the redistribution set actions to be performed when
all the match criteria of a route map are met. When all match criteria are met, all set actions are
performed.
Note This command is not supported for redistributing routes into Border Gateway Protocol (BGP).
This command requires the LAN Enterprise Services license.
Examples This example shows how to set the metric type of the destination protocol to OSPF external Type 1:
switch# configure terminal
switch(config)# route-map map-type
switch(config-route-map)# set metric-type type-1
switch(config-route-map)#
internal Specifies the Interior Gateway Protocol (IGP) metric as the multi-exit
discriminator (MED) for BGP.
type-1 Specifies the Open Shortest Path First (OSPF) external Type 1 metric.
type-2 Specifies the OSPF external Type 2 metric.
Release Modification
5.0(3)A1(1) This command was introduced.
To Next Page
Loading...
Need help?
General
