Cisco Nexus 3548 User Manual

503
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Show Commands
show ip rip route
show ip rip route
To display route information from the Routing Information Protocol (RIP) topology table, use the show
ip rip route command in any mode.
show ip rip route [prefix/length] [summary] [vrf vrf-name]
Syntax Description
Command Default No default behavior or values
Command Modes Any command mode
Command History
Examples This example shows how to display route information from the RIP topology table:
switch# show ip rip route
Related Commands
prefix/length (Optional) IP prefix about which routing information should be displayed.
summary (Optional) Displays information about summary routes.
vrf vrf-name (Optional) Specifies the name of the virtual routing and forwarding (VRF)
instance. The vrf-name argument can be specified as any case-sensitive,
alphanumeric string up to 32 characters. The strings “default” and “all” are
reserved VRF names.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
show ip rip Displays RIP information.
show ip rip interface Displays RIP information for an interface.
show ip rip neighbor Displays RIP information for a neighbor.
show ip rip policy statistics Displays policy statistics for RIP.
show ip rip statistics Displays RIP statistics.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back