EasyManuals Logo

Cisco Nexus 3548 User Manual

Cisco Nexus 3548
556 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #379 background imageLoading...
Page #379 background image
359
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
soft-reconfiguration inbound (BGP)
soft-reconfiguration inbound (BGP)
To configure the switch software to start storing Border Gateway Protocol (BGP) peer updates, use the
soft-reconfiguration inbound command. To not store received updates, use the no form of this
command.
soft-reconfiguration inbound
no soft-reconfiguration inbound
Syntax Description This command has no arguments or keywords.
Command Default Disabled
Command Modes Neighbor address-family configuration mode
Command History
Usage Guidelines Entering this command starts the storage of updates, which is required to do inbound soft
reconfiguration.
To use soft reconfiguration, or soft reset, without preconfiguration, both BGP peers must support the soft
route refresh capability.
This command requires the LAN Enterprise Services license.
Examples This example shows how to configure the soft reconfiguration on the neighbor at 192.168.0.1:
switch# configure terminal
switch(config)# router bgp 102
switch(config-router)# neighbor 192.168.0.1 remote-as 201
switch(config-router-neighbor)# address-family ipv4 unicast
switch(config-router-neighbor-af)# soft-reconfiguration inbound
switch(config-router-neighbor-af)#
Related Commands
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
address-family (BGP) Enters the router in address family configuration mode for configuring BGP
routing sessions.
neighbor Configures a BGP neighbor.
show ip bgp neighbors Displays BGP peer information.

Table of Contents

Other manuals for Cisco Nexus 3548

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Nexus 3548 and is the answer not in the manual?

Cisco Nexus 3548 Specifications

General IconGeneral
Rack Units1RU
Product TypeSwitch
Form FactorRack-mountable
Jumbo Frame Support9216 bytes
Input Voltage100-240 VAC
Product SeriesNexus 3000
ModelNexus 3548
Operating SystemCisco NX-OS
Ports48 x 10GE SFP+
Latency190 ns
AirflowFront-to-back

Related product manuals