Cisco Nexus 3548 User Manual

402
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
vrf member
vrf member
To add an interface to a virtual routing and forwarding (VRF) instance or to configure object tracking
on a VRF instance, use the vrf member command. To remove the object tracking for this route, use the
no form of this command.
vrf member vrf-name
no vrf member vrf-name
Syntax Description
Command Default None
Command Modes Interface configuration mode
Object tracking confiuration mode
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to track an IP route in VRF Red:
switch# configure terminal
switch(config)# track 1 ip route 10.10.10.0/8 reachability
switch(config-track)# vrf member Red
switch(config-track)#
This example shows how to add the Ethernet interface 1/5 to VRF RemoteOfficeVRF:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# vrf member RemoteOfficeVRF
switch(config-if)#
Related Commands
vrf-name VRF name. The name can be any case-sensitive, alphanumeric string up to
32 characters.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
show ip eigrp Displays Enhanced Interior Gateway Routing Protocol (EIGRP)
information.
show ip ospf interface Displays Open Shortest Path First (OSPF) interface-related information.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back