237
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
match ip next-hop prefix-list
match ip next-hop prefix-list
To redistribute any IPv4 routes that have a next-hop router address passed by one of the access lists
specified, use the match ip next-hop prefix-list command. To remove the next hop entry, use the no
form of this command.
match ip next-hop prefix-list prefix-list-name [...prefix-list-name]
no match ip next-hop prefix-list prefix-list-name [...prefix-list-name]
Syntax Description
Command Default Routes are distributed freely, without being required to match a next hop address.
Command Modes Route-map configuration mode
Command History
Usage Guidelines An ellipsis (...) in the command syntax indicates that your command input can include multiple values
for the prefix-list-name argument.
Use the route-map global configuration command, and the match and set route-map configuration
commands to define the conditions for redistributing routes from one routing protocol into another. Each
route-map command has a list of match and set commands associated with it. The match commands
specify the match criteria—the conditions under which redistribution is allowed for the current
route-map command. The set commands specify the set actions—the particular redistribution actions
to perform if the criteria enforced by the match commands are met. The no route-map command deletes
the route map.
The match route-map configuration command has multiple formats. The match commands can be given
in any order and all match commands must pass to cause the route to be redistributed according to the
set actions given with the set commands. The no forms of the match commands remove the specified
match criteria.
When you are passing routes through a route map, a route map can have several parts. Any route that
does not match at least one match clause that relates to a route-map command is ignored; that is, the
route is not advertised for outbound route maps and is not accepted for inbound route maps. If you want
to modify some particular data, you must configure a second route map section with an explicit match
specified.
This command requires the LAN Enterprise Services license.
prefix-list-name Number or name of a prefix list. It can be any alphanumeric string up
to 63 characters. The ellipsis indicates that multiple values can be
entered, up to 32 prefix lists.
Release Modification
5.0(3)A1(1) This command was introduced.
To Next Page
Loading...
Need help?
General
