Cisco Nexus 3548 User Manual

217
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
log-adjacency-changes (EIGRP)
log-adjacency-changes (EIGRP)
To enable the logging of changes in the Enhanced Interior Gateway Routing Protocol (EIGRP) adjacency
state, use the log-adjacency-changes command. To disable the logging of changes in the EIGRP
adjacency state, use the no form of this command.
log-adjacency-changes
no log-adjacency-changes
Syntax Description This command has no arguments or keywords.
Command Default Adjacency changes are not logged.
Command Modes Address-family configuration mode
Router configuration mode
Router VRF configuration mode
Command History
Usage Guidelines This command requires the LAN Enterprise Services license.
Examples This example shows how to enable logging of adjacency state changes for EIGRP 1:
switch# configure terminal
switch(config)# router eigrp 1
switch(config-router)# address-family ipv4
switch(config-router-af)# log-adjacency-changes
switch(config-router-af)#
Related Commands
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
ip eigrp
log-neighbor-changes
Logs changes to neighbors for an interface.
ip eigrp
log-neighbor-warnings
Logs neighbor warnings for an interface.
show ip eigrp interfaces Displays information about EIGRP interfaces.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back