Cisco Nexus 3548 User Manual

111
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
default-metric (RIP)
default-metric (RIP)
To set default metric values for the Routing Information Protocol (RIP), use the default-metric
command in router address-family configuration mode. To return to the default state, use the no form of
this command.
default-metric value
no default-metric [value]
Syntax Description
Command Default value: 1
Command Modes Router address-family configuration mode
Command History
Usage Guidelines Use the default-metric command with the redistribute command to use the same metric value for all
redistributed routes. A default metric helps to solve the problem of redistributing routes with
incompatible metrics. Whenever external metrics do not convert to RIP metrics, you can use a default
metric to provide a reasonable substitute to the external metric and enable the redistribution to proceed.
This command does not require a license.
Examples This example shows how to advertise Open Shortest Path First (OSPF) routes using RIP and assign the
OSPF-derived routes with a RIP metric of 10:
switch# configure terminal
switch(config)# router rip Enterprise
switch(config-router)# address-family ipv4 unicast
switch(config-router-af)# default-metric 10
switch(config-router-af)# redistribute ospf 109 route-map FilterOSPF
switch(config-router-af)#
Related Commands
value Default metric value. The range is from 1 to 15.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
address-family Enters address-family configuration mode.
copy running-config
startup-config
Saves the configuration to the startup configuration file.
default-information
originate
Generates a default route for routes redistributed into RIP.

Cisco Nexus 3548 Specifications

General

Rack Units	1RU
Product Type	Switch
Form Factor	Rack-mountable
Jumbo Frame Support	9216 bytes
Input Voltage	100-240 VAC
Product Series	Nexus 3000
Model	Nexus 3548
Operating System	Cisco NX-OS
Ports	48 x 10GE SFP+
Latency	190 ns
Airflow	Front-to-back

Summary

New and Changed Information

Preface

Describes audience, organization, and conventions of the document.

Document Conventions

Explains conventions used in command descriptions and screen examples.

Related Documentation

Lists other Cisco documentation for related products.

Unicast Routing Commands

additional-paths receive

Enables BGP additional paths for a prefix to be received from a capable peer.

address-family (BGP neighbor)

Enters neighbor address family mode for configuring BGP routing protocols.

area authentication (OSPF)

Enables authentication for an Open Shortest Path First (OSPF) area.

aggregate-address (BGP)

Creates a summary address in a Border Gateway Protocol (BGP) routing table.

authentication (HSRP)

Configures authentication for the Hot Standby Router Protocol (HSRP).

distance (EIGRP)

Sets administrative distances for EIGRP internal and external routes.

redistribute (BGP)

Injects routes from one routing domain into the Border Gateway Protocol (BGP).

router bgp

Assigns an autonomous system (AS) number and enters BGP configuration mode.

neighbor

Configures a Border Gateway Protocol (BGP) neighbor and enters configuration mode.

Unicast Routing Show Commands

show bgp

Displays Border Gateway Protocol (BGP) routes.

show ip eigrp neighbors

Displays information about neighbors discovered by EIGRP.

show ip ospf neighbors

Displays Open Shortest Path First (OSPF)-neighbor information on a per-interface basis.

show ip route

Displays routes from the unicast Routing Information Base (RIB).

show running-config

Displays the running configuration.

show vrrp

Shows information about the Virtual Router Redundancy Protocol (VRRP).