113
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
OL-27852-01
Chapter Unicast Routing Commands
delay minimum
delay minimum
To delay the Hot Standby Router Protocol (HSRP) initialization after a reload or after an interface comes
up, use the delay minimum command. To disable this function, use the no form of this command.
delay minimum [min-delay] reload [reload-delay]
no delay minimum [min-delay] reload [reload-delay]
Syntax Description
Command Default The HSRP delay default is 0 seconds.
Command Modes Interface configuration mode
Command History
Usage Guidelines The delayed HSRP initialization configuration allows the interface and router to stabilize after the
interface comes up and helps to prevent HSRP state flapping.
This command does not require a license.
Examples This example shows how to configure a minimum delay of 3 seconds and a group initialization delay of
10 seconds:
switch# configure terminal
switch(config)# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# ip address 192.168.9.5 255.255.255.0
switch(config-if)# hsrp 1
switch(config-if)# delay minimum 3 reload 10
switch(config-if)# ip 192.168.0.100
switch(config-if)#
Related Commands
min-delay Minimum time (in seconds) to delay HSRP group initialization after an
interface comes up. This period applies to all subsequent interface events.
The default is 0 seconds.
reload reload-delay Specifies the time period to delay HSRP group initialization after the router
has reloaded. This period applies only to the first interface-up event after the
router has reloaded. The default is 0 seconds.
Release Modification
5.0(3)A1(1) This command was introduced.
Command Description
feature hsrp Enables the HSRP configuration.
To Next Page
Loading...
Need help?
General
